PLACEMENT SOLUTION

JUKI’s PLACEMENT SOLUTION encompasses a large portfolio of placement machines intended for small, mid-sized and large companies who are looking for flexible, reliable and long-term solutions. JUKI placement machines perform high-quality work whilst ensuring overall the precisely accurate placement of components on printed circuit boards. Consequently allowing a reliable long-term planning.

RS-1

Placement Solution

JUKI Placement Solution - RS-1

RS-1R

Next Generation Smart Fast Modular Mounter

The consistent further development of the tried-and-tested technologies from the RS-1 opens up new, outstanding possibilities:

Even faster assembly of smallest chips (0201 metric) up to large components of 50 x 150 mm or 74 mm edge length for square components. The base frame of the RS-1R has been completely redesigned for this purpose. The unique Takumi head covers even more different component heights and thus achieves a decisive speed advantage. The 360 ° visual component recognition allows the secure detection of user-specific polarity marks. Thanks to the RFID integration in the nozzles, these can be traced back completely together with the components and boards. The machine combines the features of a chip shooter with a mounter for large components. The purchase of each special machine type for it eliminates as well as a change of the placement head.

Faster Placements

Thanks to the completely redesigned base frame, significantly higher speeds than previously are possible. 6 different head heights give the highly flexible mounter a significant increase in performance.

The RS-1 family has the unique TAKUMI (Japanese for “master”) head. This lowers for small components down to a distance of 1 mm down to the PCB. This minimizes the travel distance of the individual placement axes (8 units) and enables the decisive speed advantage in placing the smallest components which are usually represented in the largest number on the PCB.

Highest flexibility

The RS-1 supports a large component spectrum with components from 0201 (metric) to 74 mm (square) or 50 x 150 mm (rectangular). The standard component height of up to 25 mm completes the high flexibility.

Changing the placement head is not necessary!

Meets highest standards

Vision Teaching supports the visual learning of new components on the machine within a few minutes. You decide which component properties are important.

There is even more space in the magazine for a wide variety of nozzles, and nozzles can be optionally accommodated up to a size of 7x28mm.

For even more comfort and ease of use, the feeder trolleys have been redesigned and an on-screen keyboard has been integrated.

Board Size

max. 650 mm × 370 mm (single clamping)

Component Height

25 mm

Component Size

0201*2 (metrisch) ~ 74 mm / 50 × 150 mm

Placement Rate

IPC9850:

29,000 CPH

Placement Accuracy

± 0.035 mm (Cpk ≥ 1)

Feeder Spaces

max. 112

Power Supply

200 – 415 VAC, 3-phase

Apparent Power

2.2 kVA

Operating Air Pressure

0,5 ± 0,05 MPa

Air Consumption

max. 50 L / min

Machine Dimensions (W × D × H)

1,500 × 1,810 × 1,440 mm

Mass (approximately)

1.700 kg

 

*1 250 mm conveyor extension required 
*3 When unsing RF Feeders on front and rear 

 

Please refer to product specifications for details.
Specifications and design subject to change without notice.

This website uses cookies. By using this website you consent to our use of cookies. More

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close