
PLACEMENT SOLUTION
JUKI’s PLACEMENT SOLUTION encompasses a large portfolio of placement machines intended for small, mid-sized and large companies who are looking for flexible, reliable and long-term solutions. JUKI placement machines perform high-quality work whilst ensuring overall the precisely accurate placement of components on printed circuit boards. Consequently allowing a reliable long-term planning.
RS-1XL
RS-1XL for everyone who wants to assemble larger circuit boards
The RS-1XL combines the advantages of the RS-1 and RS-1R with the possibility of assembling printed circuit boards up to 560 mm wide (for comparison RS-1 / RS-1R: max. Width 370 mm). With slightly larger dimensions than a RS-1, the RS-1XL offers the same advantages: fast assembly of the smallest chips (0201 metric) to large components of 50 x 150 mm or 74 mm edge length for square components. The machine combines the properties of a chip shooter with a mounter for large components. There is no need to purchase a special machine type.
New generation of electrical feeders of the type RF
As with the normal RS-1 / RS-1R, the RF feeders are used with the RS-1XL. Due to its compact design, up to 112 feeders can be used on the machine.
Larger board width
The RS-1XL processes circuit boards up to 650 (length) x 560 mm (width) in size. There can be 3 circuit boards in the machine, one in the waiting position at the entrance, one in the assembly and one in the exit. This optimizes a cycle time.
High flexibility – chip shooter and mounter in one machine
The RS-1 family is fetured with the unique TAKUMI (Japanese for “master”) placement head. In the case of small components, this lowers down to a distance of 1 mm onto the circuit board. This minimizes the travel of the individual placement heads (8 pieces) and enables the decisive speed advantage when assembling the smallest components, which are usually represented in large numbers on the circuit board. For larger components, the TAKUMI placement head increases the distance to the circuit board. The setting at which height the placement head is located is determined by the opting algorithm in the programming software. With several RS-1 machines in a line in particular, the components on the circuit board are always used to optimize the machines so that they are fully utilized with the fastest possible assembly.
Board Size
max. 650 mm × 560 mm (single clamping)
Component Height
25 mm
Component Size
0201*2 (metric) ~ 74 mm / 50 × 150 mm
Placement Rate
Nach IPC9850:
29,000 CPH
Placement Accuracy
± 0.035 mm (Cpk ≥ 1)
Feeder Spaces
max. 112*3
Power Supply
200 – 415 V, Dreiphasenwechselstrom
Apparent Power
2.2 kVA
Operating Air Pressure
0.5 ± 0.05 MPa
Air Consumption
max. 50 L / min
Machine Dimensions (W × D × H)
2,109 × 2,000 × 1,490 mm
Mass (approximately)
1.85 t
*1 250 mm conveyor extension required.
*2 Ask for availability.
*3 When unsing RF Feeders on front and rear.
Please refer to product specifications for details.
Specifications and design subject to change without notice.